Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1813 - Manual (Page 19)

3. Installation
PNEG-1813 Electronic Distributor Control 19
Control Motor Installation
Install the motor (DEC0015) to the motor mounting bracket (DEC0003) using two (2) 1/4"-20 x 1" HHCS
bolts (S-6998), four (4) 1/4" washers (S-2126) and two (2) 1/4"-20 nylock nuts (S-7025) as shown
in
Figure 3L .
Install second motor mounting bracket (DEC0021) to the enclosure (DEC0005) using two (2) 1/4"-20 x
3/4" HHCS bolts (S-1429), 1/4" washers (S-2126) and 1/4"-20 nylock nuts (S-7025). Then install the motor
to the motor mounting bracket (DEC0021) using two (2) 1/4"-20 x 1" HHCS bolts (S-6998), four (4)
1/4" washers (S-2126) and two (2) 1/4"-20 nylock nuts (S-7025) as shown in
Figure 3L .
Figure 3L Control Motor Installation