Veris Technologies MSP3 - Operating Instructions - Manual (Page 74)

Pub. #OM17-MSP3
5-10
Wear Item Replacement
Inspect cutting shoe for wear and gouges, replace as needed. Knock old shoe off with punch and
tap new shoe on, as shown here. TIP: Rotate cutting shoe to prolong wear life.
Figures 24a and 24b
Replace sampling trough liner, scraper cutting edge when wear is apparent.
Closing disk Lubrication
The closing disks each have a grease zerk on them (right and left side). Due to the constant
rotation, these should be lubricated on 80
–hour intervals.
Figure 25 Closing Disk grease zerks
knock worn shoe
off from rear
tap new shoe on
with 2x4