Veris Technologies MSP3 - Operating Instructions User Manual
Page 59
Pub. #OM17-MSP3
4-39
pH readings
from each
electrode
Status of pH
controller; Green
means the
controller is
engaged while
Red means it is
disengaged and
will not
automatically
cycle
Ground
speed (from
GPS) in
miles/hour
GPS status:
may read
GPS, DGPS,
RTK, or None
Shallow (Sh) and
Deep (Dp) soil EC
readings. If negative,
no data is being
saved.
Point size for EC,
OM and pH values;
adjust point size to
fill transects and
display spatial
structure to map.
Ranges used to map pH values. Each color
should have a unique range associated with
it. These are user-defined ranges and can
be changed at any time. If points appear
to be missing from the map, it could be that
they are out of the ranges selected. pH min
and pH max can be used as guidelines for
setting up the pH ranges. Up to five
divisions can be selected
These EC and OM
ranges are not user
selectable and are
set by the software
which gives each
range the same
number of points.
Colors for the graphs
can be set here, by
clicking on the color
box and selecting a
new color.
Control used to
change
between EC
arrays
Status of pH
sampling
mechanism
OM/EC Comm.
and pH Comm.
Lights; when
green these
indicate there is
communication
with the
controllers.
Cancel Search
– This stops
the software
from searching
for the pH or
OM controllers.
This is helpful
when the
operator only
wants to map
EC and OM, or
in previewing
data that was
previously
collected.
Figure 97