Veris Technologies MSP3 - Operating Instructions - Manual (Page 21)

Pub. #OM17-MSP3
4-1
Section 4
Field Operations: DataLogger: OM and pH System Checks
Sensor DataLogger display readings
Here are the display readings shown when operating the Sensor DataLogger:
Starting up…
Figure 1
The unit is ready to operate. The DataLogger is informing you of the firmware version its
programmable interface chip (PIC) contains.
Press any of the four keys, and the next screen will appear:
Figure 2
For Mapping, press the #1 key. For OM System check press the #2 key (page 4-4). #4 Exit
returns you to the initial start-up screen. Pressing #1 brings up the next screen:
Figure 3
For EC and OM mapping, press the #1 key. For EC, OM and pH press the #2. #4 Exit returns you
to the initial start-up screen. Pressing #1 or #2 brings up the next screen:
Figure 4
The DataLogger is displaying the map file number it is creating, in case you want to record it along
with any other information about the field. Press any key to begin new map file. After starting the
file, pressing the #4 key will stop the file. If DataLogger freezes at the screen shown in Figure 6 or
Figure 7, check formatting of SD card
—must be FAT format. See Proc. #6 for formatting
instructions.