Veris Technologies MSP3 - Operating Instructions - Manual (Page 10)

Pub. #OM17-MSP3
2-1
Section 2
Electronics Overview and Set-up
The MSP3 electronics kit and optional DataLogger kit are shown below.
Figure 1a MSP3 electronics kit Figure 1b MSP3 DataLogger kit
Use protective shipping/storage case to protect electronics components whenever electronics are
shipped. Keep all diagnostics and operations manual with system when mapping.
Mount electronics in a location that is as free as possible from dust, vibration, and electrical
interference. Display should be visible to operator and shielded from direct sunlight.
‘
The supplied GPS(Figure 2) is configured to operate
with the MSP3 electronics.
The use of any other GPS requires the correct
settings. The GPS needs to output only two NEMA
strings(GGA and VTG OR RMC). The system will
not run with more than two strings. The strings
need to output at 4800 baud and 1Hz refresh rate.
USB Serial
Adapter
MSP3 EC
Test Box
pH
Simulator Mounting
Bracket
OM
Reference
Block
OM test
load
MSP3 EC
test load
SoilViewer
Protective
Case
Three-way
power
adapter
DataLogger
SD card
reader
Power Cord
Figure 2