Veris Technologies VIS-NIR-EC-Force P4000 Spectrophotometer - QUICK REFERENCE CARD - Manual

Veris P4000 Vis-NIR-EC-Force
Spectrophotometer
QUICK REFERENCE CARD
(Refer to Operations Manual for complete instructions, including
software installation, safety, maintenance, and troubleshooting.)
1. Start up spectrometers 20
minutes before using. Leave
vehicle running to keep battery
charged. (amperage draw is 10
amps if cooler is running; 1 amp
otherwise)
7. Clean window, and place reference block against
window. Press Dark and Reference button (F2). Multiple
Dark and Reference readings may need to be collected
2. Start software.
Refer to Operating
Instructions for
software installation
procedure.
9. Press End
(F12) to transform.
10. Green light
indicates when
transform is
complete. READY
TO MOVE TO
NEXT STEP—
DATA
ACQUISITION.
Press Close
Window/F12 to
move back to
main interface
screen.
8. Press external references (ER)
against window. Press
corresponding button when Program
State reads REST. Continue until all
ER lights are green or yellow.
3. Select field folder 4. Set port order (if changed)
6. Press System Check button
5. Toggle to Probe mode