Veris Technologies MSP3 - Operating Instructions - Manual (Page 22)

Pub. #OM17-MSP3
4-2
If memory card was not inserted during boot-up, the following screen will appear:
Figure 5
Install card and re-start DataLogger. NEVER REMOVE CARD WHILE LOGGING DATA.
This is the Data Acquisition screen with GPS status (note:GPS status will blink every second when
engaged to show the OM readings):
Figure 6
Figure 7 The acquisition screen with OM readings
Ground
speed (from
GPS) in
miles/hour GPS status: may
read GPS,
DGPS, RTK, or
None. If None, no
GPS signal is
received and no
data will be
recorded.
Shallow (S)
and Deep (D)
soil EC
readings. If
negative, no
data will be
recorded.
pH sampler status
pH readings from
electrodes 1 and
2
OM reflectance
readings the top
is RED the
bottom is IR
Shallow (S) and
Deep (D) soil EC
readings. If
negative, no data
will be recorded.
pH readings
from electrodes
1 and 2
pH sampler status