Veris Technologies MSP3 - Operating Instructions - Manual (Page 13)

Pub. #OM17-MSP3
2-4
Electronic Configurations
Datalogger
– Attach the OpticMapper/EC Controller communication cable to the EC port on the
Datalogger, then the communication cable from the pH Controller to the pH port. Connect EC
signal cable, GPS, and power cords to the OM/EC controller.
Figure 9
Soilveiwer
– Connect both communication cables from OpticMapper/EC Controller and from the pH
Controller to Laptop using the supplied USB to Serial converters. Connect EC signal cable, GPS,
and power cords to the OM/EC controller.
Figure 10