Acnodes FPC 6084 User Manual

Page 80

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6065 / 6084

IDE UDMA[Auto]

Use the IDE UDMA option below to select the Ultra DMA (UDMA) mode for the followingHDDs:

IDE Primary Master UDMA
IDE Primary Slave UDMA

Auto (Default)

The computer selects the correct UDMA.

Disabled

The UDMA for the HDD device is disabled.

IT8888 ISA Decode IO

Use the IT8888 ISA Decode IO menu (BIOS Menu 7) to set the IO memory range for the onboard ISA. See
Section 5.5.1.

IT8888 ISA Decode Memory

Use the IT8888 ISA Decode Memory (BIOS Menu 8) to set the resources for the onboard ISA bus. See
Section 5.5.2.

IDE HDD Block Mode [Enabled]

If the drive connected to the system supports block mode, use the IDE HDD Block Mode option to enable
the system to detect the optimal number of block read/writes per sector the system IDE drive can support.
Block mode is also called block transfer, multiple commands, or multiple sector read/write.

Disabled

Block mode is not supported.

Enabled

(Default)

Block mode is supported.

Onboard FDC Controller [Disabled]

Use the Onboard FDC Controller option to enable or disable the onboard floppy controller. If the
system is not connected to a floppy disk or uses an adapter for the FDD,
this option can be disabled.

Disabled(Default)

The FDD controller is disabled.

Enabled

The FDD controller is enabled.

Onboard Serial Port 1 [3F8/IRQ4]

Use the Onboard Serial Port 1 option to select the I/O address and IRQ for the onboard serial port 1. The
serial port can be disabled or the I/O address and the IRQ can be automatically selected by the BIOS. The
Onboard Serial Port 1 options are:

Disabled
3F8/IRQ4 (Default)
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Auto