Acnodes FPC 6084 User Manual

Page 38

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6065 / 6084

Step 4: Connect the IDE/SATA cable from the IDE/SATA connector on the otherboard
to the rear of HDD. Reconnect the fan cable to the motherboard.

Step 5: Install the HDD into the FPC6065 by aligning the retention screw holes in the
HDD brackets with the retention screw holes on the chassis. Insert the three retention
screws.

3.8.2 FPC6084 HDD INSTALLATION

To install the HDD into the FPC6084, please follow the steps below:

Step 1: Remove the back cover. See Section 3.5.2 above.

Step 2: The HDD bracket is attached to the platform by four retention screws. Remove the four retention
screws from the platform (Figure 3-13).

Step 3: Attach the HDD brackets to the HDD. To do this, align the four retention screw holes in the base of
the HDD bracket with the retention screw holes on the bottom of the HDD. Insert four retention screws into
the HDD bracket from the bottom (Figure 3-14).