1 jp1: at power select jumper settings, 2 cn7: clear cmos setup – Acnodes FPC 6084 User Manual

Page 32

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6065 / 6084

3.6.1 JP1: AT POWER SELECT JUMPER SETTINGS

The AT/ATX Power Mode Select jumper specifies the systems power mode.

3.6.2 CN7: CLEAR CMOS SETUP

NOTE:
The battery connector (CN7) is used as the clear CMOS jumper on the motherboard.

If the motherboard fails to boot due to improper BIOS settings, use this jumper to clear the CMOS data and
reset the system BIOS information. To do this, use the jumper cap to close pins 2 and 3 for a few seconds
then reinstall the jumper clip back to pins 1 and 2.

If the "CMOS Settings Wrong" message displays during the boot up process, try to correct the fault by
pressing the F1 to enter the CMOS Setup menu. Then do one of the following: