3 installation and configuration steps, 4 unpacking – Acnodes FPC 6084 User Manual

Page 28

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6065 / 6084

3.3

INSTALLATION AND CONFIGURATION STEPS

The following installation steps must be followed.

Step 1: Unpack the flat panel PC

Step 2: Set the jumper settings

Step 3: Install system fan

Step 4: Install HDD

Step 5: Install the SO-DIMM memory module

Step 6: Mount the flat panel PC

Step 7: Connect peripheral devices to the bottom panel of the flat panel PC

Step 8: Configure the system

3.4

UNPACKING

To unpack the flat panel PC, follow the steps below:

WARNING!
The front side LCD screen has a protective plastic cover stuck to the screen. Only remove the plastic cover
after the flat panel PC has been properly installed. This ensures the screen is protected during the
installation process.
Step 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the external (second)
box.

Step 2: Open the external (second) box.

Step 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the internal (first) box.

Step 4: Lift the monitor out of the boxes.

Step 5: Remove both polystyrene ends, one from each side.

Step 6: Pull the plastic cover off the flat panel PC.

Step 7: Make sure all the components listed in the packing list are present.