3 arm mounting – Acnodes FPC 6084 User Manual

Page 51

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6065 / 6084

3.12.3 ARM MOUNTING

The FPC6065/FPC6084 is VESA (Video Electronics Standards Association) compliant and can be
mounted on an arm with a 100mm interface pad. To mount the FPC6065/FPC6084 on an arm,
please follow the steps below.

Step 1: The arm is a separately purchased item. Please correctly mount the arm onto the surface it uses
as a base. To do this, refer to the installation documentation that came with the mounting arm.

NOTE: When purchasing the arm please ensure that it is VESA compliant and that the arm has a 100mm
interface pad. If the mounting arm is not VESA compliant it cannot be used to support the FPC6065/
FPC6084 flat panel PC.

Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel PC onto the
interface pad of the mounting arm.

Step 3: Align the retention screw holes on the mounting arm interface with those in the flat panel PC. The
flat panel PC arm mount retention screw holes are shown in Figure 3-31.