2 installation steps unser existing windows xp – Acnodes FPC 6084 User Manual

Page 45

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6065 / 6084

Step 6: The setup program continues, later when the setup program prompts users to specify additional
adapters, please press the S key.

Step 7: The setup program prompts user to insert the driver diskette. Please insert the driver diskette, and
press ENTER to continue.

Step 8: The follow-up window lists out the installation choices, please select ALi SATA/RAID Controller for
Windows XP and press ENTER to continue.

Step 9: The follow-up window lists out the devices to be installed, in which selected ALi controller(s) should
be included.

Step 10: Repeat step 5, but select ALi ATA/RAID Controller at step 7. If both controllers are installed, go to
next step.

Step 11: If users want to install other devices, please operate at this time. If all devices have been success-
fully installed, please go to next step.

Step 12: Press ENTER to continue Windows XP setup.

3.11.2 INSTALLATION STEPS UNSER EXISTING WINDOWS XP

After Windows XP is started, Windows system automatically finds the newly installed adapter and prompts
user to install its driver. Please follow these steps to install the driver:

Step 1: When the Found New Hardware Wizard windows appear (Mass Storage Controller), select Install
from a list or specify location (Advanced) and click Next to continue.

Step 2: In the follow-up window, please select "Don't search, I will choose the driver to install", then click
Next to continue.

Step 3: In the follow-up window, please select SCSI and RAID controllers, and then click Next to continue.

Step 4: In the follow-up window, click Have Disk, then insert the driver diskette and type in the driver loca-
tion: e.g., a CD-ROM, then click OK to continue.

Step 5: In the follow-up window, select ALi SATA/RAID Controller, then click Next to continue.

Step 6: Confirm the follow-up windows and click the Finish button to continue.