6 jumper settings – Acnodes FPC 6084 User Manual

Page 31

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6065 / 6084

3.5.2 FPC6084 BACK COVER REMOVAL

The back cover is secured to the chassis with seven retention screws on the rear panel (Figure 3-2). Re-
move the seven retention screws and lift the cover off the FPC6084.

3.6 JUMPER SETTINGS

A jumper is a metal bridge that is used to close an electrical circuit. It consists of two metal pins and a
small metal clip (often protected by a plastic cover) that slides over the pins to connect them.
To CLOSE/SHORT a jumper means connecting the pins of the jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a jumper.

The WAFER-LX comes with three jumpers. They are listed below.

AT power select (JP1)

COM 2 mode setup (JP2)

Clear CMOS (CN7)