ZyXEL Communications 480 - Manual (Page 83)

Prestige 480 ISDN Router
Dial-In Server Configuration 6-7
6.3.1 Default Dial-in Filter
Move cursor to the field Edit Filter Sets in Menu 13, press space bar to toggle and set the value to
Yes and then press [Enter] to open Menu 13.1 – Default Dial-in Filter.
Use this menu to specify the filter set(s) to apply to the incoming and outgoing traffic between all
dial-in users and your Prestige. Note that the filter set(s) only applies to the dial-in users but not
the remote nodes. You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each
filter field. The default is no filters.
Spaces are accepted in this field. For more information on defining the filters, see Chapter 9.
Figure 6-4 Default Dial-in Filter
6.4 Dial-In Users Setup
The following steps describe the setup procedure for setting up a remote dial-in application.
Step 1. From the Main Menu, enter option 14 to go to Menu 14 - Dial-in User Setup, as shown
in the next figure.
Figure 6-5 Menu 14 - Dial-in User Setup
Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Menu 14 - Dial-in User Setup
1. ---------
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter Menu Selection Number: