ZyXEL Communications 480 - Manual (Page 134)

Prestige 480 ISDN Router
11-16 System Maintenance
11.6.2 Uploading Router Configuration File
The configuration data, system-related data, the error log and the trace log are all stored in the
configuration file. Please be aware that uploading the configuration file replaces everything
contained within.
Menu 24.7.2 shows you the instructions for uploading the configuration file. If you answer yes to
the prompt, the Prestige will go into debug mode. Follow the procedure below to upload the
configuration file:
4. Enter “atur3” after the “Enter Debug Mode” message.
5. Wait for the “Starting XMODEM upload” message before activating Xmodem
upload on your terminal.
6. After successful firmware upload, enter “atgo” to restart the Prestige.
If you replace the current configuration file with the default configuration file, i.e., p128IMH.rom,
you will lose all configurations that you had before and the speed of the console port will be reset
to the default of 9600 bps with 8 data bit, no parity and 1 stop bit (8n1) . You will need to change
your serial communications software to the default before you can connect to the Prestige again.
The password will be reset to the default of 1234, also.
Figure 11-14 Menu 24.7.2 - System Maintenance - Upload Router Configuration File
Menu 24.7.2 - System Maintenance - Upload Router Configuration File
To upload router configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur3" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning:
1. Proceeding with the upload will erase the current router
configuration file.
2. The router's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (Menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Which To Proceed:(Y/N)