ZyXEL Communications 480 - Manual (Page 79)

Prestige 480 ISDN Router
Dial-In Server Configuration 6-3
6.2 LAN-to-LAN Server Application
Your Prestige can also be used as a dial-in server for LAN-to-LAN application to provide access
for the workstations on a remote network. For your Prestige to be set up as a LAN-to-LAN server,
you need to configure the Default Dial-In Setup to set the operational parameters for incoming
calls. Additionally, you must create a remote node for the router on the remote network (see
Chapter 5 - Remote Node Configuration).
An example of your Prestige being used as a LAN-to-LAN server is shown next.
Figure 6-2 Example of a LAN-to-LAN Server Application
Local Network Remote Network
Prestige 480 Prestige 480
ISDN
LAN-to-LAN
Server