ZyXEL Communications 480 - Manual (Page 106)

Prestige 480 ISDN Router
7-12 Filter Configuration
Figure 7-9 Filtering Remote Node traffic
7.4.3 Default Dial-in Filter
Use Menu 13.1 Default Dial-in Filter to specify the filter set(s) to apply to the incoming and
outgoing traffic between all dial-in users and your Prestige. Note that these filter set(s) only apply
to the dial-in users but not to the remote nodes. You can specify up to 4 filter sets separated by a
comma, e.g., 1, 5, 9, 12, in each filter field. The default is no filters.
Figure 7-10 Default Dial-in Filter
Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters =
Factory
Default
Filter