ZyXEL Communications 480 - Manual (Page 80)

Prestige 480 ISDN Router
6-4 Dial-In Server Configuration
6.3 Default Dial-in Setup
This section covers the default dial-in parameters. The parameters in Menu 13 affect incoming calls
from both remote dial-in users, and remote nodes until authentication is completed. Once
authentication is completed and if it matches a remote node, your Prestige will use parameters from
that particular remote node.
Figure 6-3 Menu 13 – Default Dial-in Setup
From the Main Menu, enter 13 to go to Menu 13 – Default Dial-in Setup. This section describes
how to configure the protocol-independent fields in this menu. For the protocol-dependent fields,
refer to the appropriate chapters.
The table below describes and contains information on how to configure each parameter in Menu
13 – Default Dial-in Setup.
Table 6-2 Default Dial-in Setup Fields
Field Description Option
Telco Options:
CLID Authen This field sets the CLID authentication parameter for all incoming calls.
There are three options for this field:
l None - No CLID is required.
l Required – CLID must be available, or the Prestige will not
None
Required
Menu 13 - Default Dial-in Setup
Telco Options:
CLID Authen= None
PPP Options:
Recv Authen= CHAP/PAP
Compression= Yes
Mutual Authen= No
O/G Login= 3
O/G Password= ****
Multiple Link Options:
Max Trans Rate= 256
Callback Budget Management:
Allocated Budget(min)=
Period(hr)=
IP Address Supplied By:
Dial-in User= Yes
IP Pool= No
IP Start Addr= 192.168.129.1
IP Count(1,4)= 2
Session Options:
Edit Filter Sets= No
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.