ZyXEL Communications 480 - Manual (Page 73)

Prestige 480 ISDN Router
Remote Node TCP/IP Configuration 5-5
Table 5-2 TCP/IP Remote Node Configuration
Rem IP
Address This will show the IP address you entered for this remote node in the
previous menu.
Rem IP
Subnet
Mask Enter the subnet mask for the remote network.
My WAN
Addr Some implementations, especially the UNIX derivatives, require the ISDN
link to have a separate IP network number from the LAN and each end
must have a unique address within the WAN network number. If this is the
case, enter the IP address assigned to the ISDN port of your Prestige.
Note that this is the address assigned to your local Prestige, not the
remote router.
Single
User
Account Set this field to Yes to enable the Single User Account feature for your
Prestige. Use the space bar to toggle between Yes and No. See Chapter
3 - Internet Access Application for more information on the Single User
Account feature. Yes/No
Metric The metric represents the “cost” of transmission for routing purposes. IP
routing uses hop count as the measurement of cost, with a minimum of 1
for directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be between
1 and 15. In practice, 2 or 3 is usually a good number. 1 to 15
Private This parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private
and not included in RIP broadcast. If No, the route to this remote node will
be propagated to other hosts through RIP broadcasts. Yes/No
RIP Press the space bar to select the RIP direction from Both/ None/In
Only/Out Only. (Default=Both)
Version= Press the space bar to select the RIP version from RIP-1/RIP-2B/RIP-2M. RIP-1 (default)
Once you have completed filling in the Network Layer Options Menu, press [Enter] to return to Menu 11.
Press [Enter] at the message [Press ENTER to Confirm...] to save your configuration, or press [Esc] at
any time to cancel.