ZyXEL Communications 480 - Manual (Page 47)

Prestige 480 ISDN Router
Internet Access 3-1
Chapter 3
Internet Access
This chapter shows you how to configure the LAN as well as the WAN of
your Prestige for Internet access.
3.1 Factory Ethernet Defaults
The Ethernet parameters of the Prestige are preset in the factory with the following values:
1. IP address of 192.168.1.1 with subnet mask of 255.255.255.0 (24 bits).
2. DHCP server enabled with 32 client IP addresses starting from 192.168.1.33.
These parameters should work for the majority of installations. If the parameters are satisfactory,
you can skip to section 3.4 TCP/IP Ethernet Setup and DHCP to enter the DNS server
address(es) if your ISP gives you explicit DNS server address(es). If you wish to change the factory
defaults or to learn more about TCP/IP, please read on.
3.2 Route IP Setup
The first step is to enable the IP routing in Menu 1 - General Setup.
Figure 3-1 General Setup
To edit Menu 1, enter 1 in the Main Menu to select General Setup and press [Enter].
Menu 1 - General Setup
System Name= ?
Location=
Contact Person's Name=
Press ENTER to Confirm or ESC to Cancel: