ZyXEL Communications 480 - Manual (Page 67)

Prestige 480 ISDN Router
Remote Node Configuration 4-9
Table 4-3 Remote Node PPP Options Menu Fields
Field Description Option
Standard PPP Encapsulation Select the CISCO PPP only when this remote node
is a Cisco machine; otherwise, select the Standard
PPP.
CISCO PPP
Compression You can turn on or off Stac Compression. The
default for this field is Yes.
Yes/No
(Default = Yes)
BACP Allows you to enable or disable the Bandwidth
Allocation Control Protocol (BACP).
The default for this field is Enable.
Enable/Disable
Default = Enable
Multiple Link
Options:
BOD
Calculation Select the direction of the traffic you wish to use in
determining when to add or subtract a link. The
default for this field is Transmit or Receive. Default = Transmit
or Receive
Min. Channel Allows you to set the minimum number of channels
the Prestige uses. 1~4
Max.
Channels Allows you to set the maximum number of channels
the Prestige uses. 1~4
Target Utility
(kbps) Enter the two thresholds separated by a [-] for
subtracting and adding the second port. Default=32-48
Bandwidth
Increment Allows you set bandwidth increment for the
additional channels, once the threshold is reached
additional channels are opened if the Min. Channels
is greater than one. Default = 64 Kbps
0-64
Add Persist This parameter specifies the number of seconds
where traffic is above the adding threshold before
the Prestige will bring up an additional link.
Default = 5 sec
Subtract
Persist This parameter specifies the number of seconds
where traffic is below the subtraction threshold
before your Prestige drops a link. Default = 5 sec
Once you have completed filling in Menu 11.2 - Remote Node PPP Options , press [Enter] at
the message [Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to
cancel.