Yamaha SU700 - Manual (Page 319)

APPENDIX
Installing the Options 319
Disconnect
here.
Ferrite core
Ferrite core must be on unconnected end.
Attach this end
of cable to
board.
4. Installing the AIEB1 Board
1 2
3
The optional AIEB1 Input/Output expansion board adds digital I/O (both optical and
coaxial formats) and six assignable outputs to the SU700.
Preparation
1. The SU700 package includes a short flat cable and a short round 3-wire cable spe-
cially designed for use with the AIEB1 board. Be sure that you have these cables on
hand. Note that one end of the short flat cable is “banded” (has a bulging ferrite core
near the connector), while the other end has no band.
2. Remove the AIEB1 board from its package, and check that three cables are attached.
The board ships with three attached cables, as illustrated above.
1 Long flat cable
2 Long round 3-wire cable
3 Round 4-wire cable
3. Disconnect the long flat cable and the long round 3-wire cable from the board, and
store or discard them. Note the location of the board connectors to which these
cables were attached.
These cables are not appropriate for use in the SU700.
4. Connect the non-banded end of the short flat cable (described in Step 1 above) to the
now-empty flat-cable connector on the board (connector “CN2”).
Be sure to connect the non-banded end, leaving the banded end free.
Connect short flat cable and short 3-wire cable (supplied with the SU700 package) here.