Yamaha SU700 - Manual (Page 211)

Chapter 8 Knob Functions 211
CHAPTER
8
EFFECT Group
You use this group to control the effect levels on each track, and to set or change the
effect resolution for each effect.
The SU700 includes a sophisticated effects implementation that provides you with
three separate effect blocks. You can assign a different effect to each block (from a to-
tal of 43 effects), set a variety of parameters for each of these effects, and adjust the
configuration of the signal flow among the three blocks. For full details about the ef-
fect implementation, refer to Chapter 7, “Effects” (
→
p.185). For a listing of the avail-
able effects and their parameters, refer to the effect listing starting on page 333.
It is important to remember that there are two different types of effects: system effects
and insertion effects. (Again, see pages 189 and 190.) The difference is as follows.
System effect: You set the effect level separately for each sample track and for the
AUDIO IN track. You cannot set the level for the MASTER track.
Insertion effect: You can set the effect level only at the MASTER track. The MASTER-
track setting determines the effect level applied to all tracks connected to the effect
block. You use the EFFECT SETUP function to switch connection to the effect block
either ON or OFF for each track. See page 190.
EFFECT 1, EFFECT 2, and EFFECT 3
Range: 000 to 127
Default: 000
Works on: If System Effect: All tracks except MASTER
If Insertion Effect: MASTER only
Press [EFFECT 1] to set knobs so that they control the levels for the effect assigned
to Effect Block 1. Press [EFFECT 2] to set knobs so that they control the levels for
the effect assigned to Effect Block 2. Press [EFFECT 3] to set knobs so that they
control the levels for the effect assigned to Effect Block 3.
The screen displays the name of the effect assigned to the corresponding block, to-
gether with the value for the most recently controlled track.