Yamaha SU700 - Manual (Page 275)

Chapter 10 Jobs 275
CHAPTER
10
Procedure
1. Before entering the job, adjust the knob values on the track you want to resample so
as to get the sound that you want to capture. Play the track (hit the pad) as often as
necessary while adjusting each of the knob settings as desired.
2. Press RESAMPLE | TRACK to enter this job.
▼ The screen displays the gain setting and the channel mode. The initially displayed
settings are the same as those you made the last time you accessed this job. (The
defaults are
GAIN=+00 , channels= L+R ). The gain setting is flashing, indicating that
you can now change this value.
3. Set the gain.
Play the source track (hit the pad as often as necessary), while turning the dial to ad-
just the gain. In general, you want to set the gain so that the maximum level brings
the meter all the way to the right side without triggering the CLIP warning.
NOTE:
If you are going to record from the AUDIO IN track, then hit the AUDIO IN pad to select
the track. You can then supply a realtime audio signal while adjusting the gain. Remem-
ber that in order to use AUDIO IN you must first set the AUDIO IN parameter (in the
SYSTEM | SETUP job) to MIC or LINE (
→
p.302).
4. Press to move to the L/R channel mode setting, and then turn the dial to select
the L/R channel mode. Then press [OK].
▼ The screen displays SOURCE TRACK, prompting you to select the source track.
5. Select the source track.
You have probably already selected the source track when adjusting the gain at step
3 above. But if necessary, you can change the setting by pressing a bank selector and/
or track pad. The bank number and meter bracket change to indicate the track selec-
tion. When you are ready, press [OK].
If you select an empty sample track, the screen displays the
NO SAMPLE message.
Change the track selection, or press [CANCEL] as necessary to return to the main
screen.