Section b.4.3, Edges curled down, B.4.3 warpage – Zebra Technologies P1013372-001 REV. A User Manual
Page 156

152
Zebra ZXP Series 8 Card Printer with Laminator
P1013372-001 Rev. A
Setting Custom Card Specifications
Adjustments
B.4.3 Warpage
Edges curled down
Warpage is usually caused by too much energy being transferred to the card; i.e., the
temperatures are too hot or the speeds are too slow.
Step 1.
Decrease Back Transfer Temperature:
a.
Go to the Card Specifications window; see
b.
Make a note of the default back transfer temperature settings.
c.
Decrease the appropriate (single or double side) back transfer temperature by 5.
d.
Click on the OK button.
e.
Print a test card; see
f.
Examine the test card.
• If there is noticeable improvement, continue decreasing the back transfer
temperature by 5, printing a test card, and examining the resulting card. Stop
when the problem is corrected or there is no more improvement. If the
problem is corrected, no more adjustment is required; otherwise go to
• If there is no noticeable improvement, return the temperature to its default
setting; and go to
.