Zebra Technologies P1013372-001 REV. A - Manual (Page 133)

Troubleshooting
Ethernet Issues
P1013372-001 Rev. A Zebra ZXP Series 8 Card Printer with Laminator 129
Ethernet Issues
If both LEDs are off, the printer has not detected the presence of a network cable. To solve
the problem:
• Verify that the network cable is appropriate and has an RJ-45 connector.
• Remove the network cable from the printer. Plug the network cable back in until you hear
a positive click. Check the other end of the cable in the same manner. If the printer still
does not detect a cable, then continue.
• Connect the printer to a known good network. If the printer is still unable to detect the
network cable, contact Technical Support for assistance.
Ethernet
Connector
Link/Activity Speed
LED LED