Zebra Technologies P1013372-001 REV. A - Manual (Page 101)

ZXP Series Toolbox
Cleaning
P1013372-001 Rev. A Zebra ZXP Series 8 Card Printer with Laminator 97
• Front Card Path
When you click on the Clean button, instructions will appear in the following sequence:
1. Insert the Y Roller Cleaning Card in the front feed slot. Click Ok after inserting
the card.
2. Wait until the cleaning process completes. The card will eject through the front
feed slot.
3. Flip the cleaning card. Insert the card through front feed slot. Click Ok.
4. Wait until the cleaning process completes. The card will eject through the front
feed slot.
5. Observe the message, Front card path cleaning successful.
6. This concludes the front card path cleaning process.
• Heater Rollers
When you click on the Clean button, instructions will appear in the following sequence:
1. Open the printer cover, remove the transfer film, and close the cover. Then, click Ok.
2. Observe the top and bottom transfer temperatures cool. Wait until the transfer
temperatures fall below 70
o
C before proceeding to the next step.
3. Remove the backing from the Hot Roller Cleaning Card. Insert the card in the front
feed slot. Click Ok.
4. Wait until the cleaning process is completed. The card will eject through the front
feed slot.
5. Flip the cleaning card. Insert card in the front feed slot. Click Ok.
6. Wait until cleaning process is completed. The card will eject through the front
feed slot.
7. Replace the transfer film.
8. Observe the message, Transfer roller cleaning successful.
9. This concludes the heater roller cleaning process.