Zebra Technologies P1013372-001 REV. A - Manual (Page 111)

P1013372-001 Rev. A Zebra ZXP Series 8 Card Printer with Laminator 107
6
C leaning
Cleaning the Printer
Clean your Printer using the Cleaning Cards provided. The regular use of these cards will
clean and maintain important parts of your printer that cannot be reached, including the
Printhead, Transport Rollers, and optional Magnetic Encoder Station.
When to Clean
• X-Roller and Y-Roller cleaning should occur every 5,000 cards.
• Heated Roller cleaning should occur every 20,000 cards. Note that a Heated Roller
Cleaning Card is not supplied with the printer; order Zebra Cleaning Card Kit
P/N 105999-801.
Caution • PROTECT YOUR FACTORY WARRANTY!
The recommended cleaning procedures must be performed to maintain your
factory warranty. Other than the recommended cleaning procedures described in
this manual, allow only Zebra authorized technicians to service the Printer.
NEVER loosen, tighten, adjust, bend, etc., any part or cable inside the printer.
NEVER use a high pressure air compressor to remove particles in the printer.