Zebra Technologies P1013372-001 REV. A - Manual (Page 100)

96 Zebra ZXP Series 8 Card Printer with Laminator P1013372-001 Rev. A
ZXP Series Toolbox
Cleaning
Cleaning
Clean Printer
The Clean Printer screen gives you the option to clean the printer via the Toolbox; refer to
Section 6 , for cleaning via the OCP.
• Side Card Path
When you click on the Clean button, instructions will appear in the following sequence:
1. Remove the card hopper, and click Ok.
2. Insert the X Roller Cleaning Card in the side slot where the card hopper was located.
Click Ok after inserting the cleaning card.
3. Wait until the cleaning process completes. The card will eject through the side slot.
4. Flip the cleaning card. Insert the card through the side slot. Click Ok.
5. Wait until the cleaning process completes. The card will eject through the side slot.
6. Observe the message, Side card path cleaning successful.
7. This concludes the side card path cleaning process.