Xerox 128 - Manual (Page 111)

DocuTech 128/155/180 HighLight Color Operator Guide 3- 65
Routine maintenance
b. Remove the cut piece of tape.
Figure 3-69 Cutting the tape
10. Close the binder drawer.
11. Close the finisher doors.
Adjusting the binder tape registration
NOTE: Production publisher configuration only
The binder tape knob is used to align the registration of the binder
tape to the top edge of a bound book.
This procedure has no effect on the length of the tape, but you
should perform this procedure before adjusting the tape length.
To adjust the length, refer to the on-line help.
Perform the following steps to adjust the binder tape registration.
1. Ensure that the tape guides are clean and free of glue residue.
Refer to the procedure, "Cleaning the binder," in this section.
2. Determine the adjustment amount for the top edge of the
book.
3. Open the finisher doors.
4. Measure the distance between the top of the binder tape and
the top of the book.
5. Locate the black binder tape knob on the front of the binder
drawer.