Tektronix Phaser 340 - Manual (Page 91)

Printing 3
User Manual 3-23
Transparency quality tips
■ For best results, use the 300 dpi print-quality setting in the
printer driver.
■ Use large type on overheads; 18 point type or larger works well.
■ Use yellow or other light colors for text on solid-color backgrounds.
■ Place slip sheets between printed transparencies or use a
protective cover to prevent contact between transparencies.
Note Do not load transparencies in the Lower Paper Tray Assembly. To
avoid a jam condition, do not re-use transparencies that have been
fed through the printer once (for example, after a jam or if the
transparency was ejected without being printed).
1. If you are using the optional transparency tray for printing
transparencies, load up to 175 transparencies (approximately three
boxes) and install the transparency tray in the printer.
When you print, use a Tektronix printer driver and specify
Transparency
to obtain the correct print mode for transparency
media. The printer senses the presence of the transparency tray
and prints correctly without further interaction.
2. If you are using the standard paper tray for printing
transparencies, replace the paper in the tray with up to 50
transparency sheets and install the paper tray in the printer.
When you print, use a supported printer driver and specify
Transparency
to obtain the correct print mode for transparency
media. The printer senses the mismatch of the transparency
media loaded in the paper tray and asks you to confirm the print
through the printer’s front panel.
Caution Never attempt two-sided or two-pass printing on any type of
media. Ink from the back side of the paper will offset onto the
internal paper path, requiring you to perform cleaning
procedures.