Tektronix Phaser 340 User Manual
Page 154
Troubleshooting
6
User Manual
6-9
Cleaning
No user action required. The printer is running an
automatic cleaning operation.
Waiting For Manual
Feed
Insert paper or transparency in the manual feed slot.
Waiting For
Transparency
The print job specifies transparency but the printer
detects that the paper tray is installed. Load
transparency in the media tray and press
OK
.
Waiting For Paper
The print job specifies paper but the printer detects that
the transparency tray is installed. Load paper in the
media tray and press
OK
.
Upper Media Tray
Empty
Add paper or transparencies to the standard media
tray.
Media Tray Empty
Add paper or transparencies to the media tray.
Lower Media Tray
Empty
Add paper to the lower media tray.
Replace Upper
Media Tray
Insert the standard media tray.
Replace Media Tray
Insert the standard media tray.
Replace Lower
Media Tray
Insert the lower media tray.
Incorrect Media
Size
An incorrect paper size is loaded in the tray or paper
narrower than A4-size is in the manual feed slot. Use
Letter- or A4-size media.
Manual Feed Paper
The printer requires a sheet of paper for cleaning but
the media tray contains transparency. Feed a sheet of
paper into the manual feed slot.
Fault. Service
Required
Turn the printer off, wait at least 15 seconds and turn
the printer’s power on again. If the failure persists, note
the code number in the display. In the U.S., call
Tektronix service at 1-800-835-6100. Outside the U.S.,
contact your local Tektronix office.
Front panel messages (cont'd.)
Message
Action