Msds for silicone oil – Tektronix Phaser 340 User Manual
Page 208
Regulatory Information
D
User Manual
D-7
MSDS for silicone oil
Section I — Product identification
Trade name and Tektronix part number:
Silicone fluid (found in maintenance tray)
006-7912-00
Product use:
Used in Tektronix Phaser 340 color printers.
Section II — Information on ingredients
Ingredients:
Polydimethylsiloxane
CAS Number: 63148-62-9
Hazardous Ingredients:
None. This is not a hazardous material as defined
by the OSHA Hazard Communication Standard.
Section III — Hazards identification
Potential health effects:
Eyes:
Direct contact may cause temporary discomfort with mild redness
and dryness similar to windburn.
Skin:
A single prolonged exposure (24 to 48 hours) causes no known
adverse effect.
Inhalation:
Not an irritant to respiratory passages.
Ingestion:
Swallowing large amounts could cause discomfort.
Section IV — First aid measures
Eyes:
Flush immediately with water.
Skin:
Wipe off and wash with soap and water.
Inhalation:
Not a likely route of exposure.
Ingestion:
No first aid should be needed.