Tektronix Phaser 340 - Manual (Page 33)

Getting Set Up 2
User Manual 2-17
Loading paper and transparency trays
1. Prior to loading paper media in a tray, fan the paper to release
sheets that are stuck together.
Note Handle transparencies by the edges and with both hands to avoid
fingerprints and creases, which can result in poor print quality.
2. If you are loading paper in the standard paper tray, load up to 200
sheets of common office paper (slightly less than one-half ream).
If you are loading transparencies in the standard paper tray, load
up to 50 transparency sheets.
3. If you are loading transparencies in the transparency tray, load up
to three boxes (175 sheets) of transparency media.
4. If you are using Tektronix premium transparency media, position
the transparency notch in the back, right corner of the tray.
Standard Tektronix transparencies can be loaded in any
orientation.
Make sure that the media fits snugly against the inside front wall of the tray.
A label on the inside of the paper and transparency trays provide a fill line to
indicate the tray’s maximum capacity.
9101-04b
2
3
1