Setting up the printer, Quick-start installation guide, Removing the packing material – Tektronix Phaser 340 User Manual
Page 24
2
Getting Set Up
2-8
Phaser 340 Color Printer
Setting up the printer
The printer is shipped to you already loaded with ink. To set up the printer
for use, follow these basic steps as described in this chapter:
■
Remove the packing material from the printer
■
Optional: Install the Lower Paper Tray Assembly
■
Unlock the printer transit restraint
■
Install the start up maintenance tray
■
Load ink sticks
■
Select a media tray configuration
■
Load the media tray(s)
Note
To ensure proper printer operation, install the printer on a flat
surface having no more than 3 degrees of tilt. This is
approximately equivalent to lifting one side of the printer up 2 cm
(0.75 inches) off of a flat surface.
Quick-Start Installation guide
A Quick-Start Installation guide is included with the printer. You may want
to reference the instructions in this guide as you set up the printer.
Removing the packing material
Remove the plastic bag and packing materials surrounding the printer.
Note
Save all boxes and packing material in case you need to ship the
printer later.