beautypg.com

Turning on the printer – Tektronix Phaser 340 User Manual

Page 41

background image

Getting Set Up

2

User Manual

2-25

Turning on the printer

After you have connected the interface cables, you are ready to connect the
power cord and turn on the printer. If you need to turn the printer off, wait
until the display shows

Ready

before powering it down.

Caution

To avoid damaging the printer, make sure that the voltage
select switch is set to match the AC line voltage for your
location and that the power switch is in the off position before
connecting the power cord.

If you move the printer to a location that uses a line voltage other than the
printer’s current setting, refer to “Changing line voltage” on page C-4 for
information on changing the line voltage selection switch.

1.

Plug the power cord into the printer and into a grounded outlet.

2.

Turn on the printer.

Note

To ensure optimum printing performance and best ink economy,
leave the printer turned on overnight and during weekends. The
printer automatically switches into a standby mode to reduce
power consumption during periods of infrequent use.

9101-50

115

Parallel

Service

port

DIP

AUX

Feeder

PHASER 340

Ethernet®

SCSI Disk

115