Toshiba Strata DK 16 - Manual (Page 81)

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
2-57
PROGRAM 15
ASSIGNING DP/DTMF, TENANT SERVICE TO INDIVIDUAL CO LINES
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data is all LEDs Off.
3. AR = Automatic Release signal. This is a momentary open of the CO line loop provided by some Central Offices. If
programmed to recognize AR, CO lines on-hold will drop when the outside party hangs up and the CO sends AR signal. Two
CO line DISA calls always release with AR. DISA line release is not related to this program—DISA calls always release with
AR signal. AR is sometimes referred to as “Calling Party Control” or “Supervised Loop Control.”
4. Tandem connection must be equipped for all DISA CO lines and all other lines used for two CO line conference.
5. If a CO line is set for Dial Pulse (DP) operation, the Tone Dial Select button must be programmed on stations that must send
DTMF tones over the CO lines. (See Program 39 to assign feature buttons.)
6. When AR is sent on a CO line call because the outside caller hangs-up, “D” tone will be sent to the voice mail (VM) port (QSTU/
PSTU/PESU/KSTU), prompting the VM machine to release and clear the port for another call.
7. The system will detect the AR signal (auto release) and drop the voice mail port when the outside caller hangs up. (See Note
3 for AR explanation.)
8. If the CO line is enabled to detect AR, the CO line will disconnect anytime during a call if the Central Office sends the AR signal.
If AR is sent when talking on a CO line with an LCD telephone, the LCD will display, “CO LINE HANG UP.”
9. See Program 10-1, LED 14, to select DK8 dial pulse rate.
1 5 P S H H Z Z
Specify CO lines by setting LEDs, as defined by the table below.
All LEDs with an "X" should be lit when finished.
Button/LEDs = CO Line
SELECT =
S
Program Code
CO Lines 01 ~ 08
(Button/LEDs)
01
(01)
02
(02)
03
(03)
04
(04)
05
(05)
07
(07)
08
(08)
06
(06)
Program
Code Program
ON OFF
LED Status
NOTE: Shaded areas apply to DK16 only
AR VM Calls/D
Tone
3,6,7,8
CO Outgoing Signal 5
CO Dial Pulse Rate
(Pulse per sec.)
AR Hold/Ring
Transfer
3,8
AR Timing 3
Tandem CO Line
Connection with Station
Dropout
4
CO Line Tenant
Assignment
Forced Account Code
Operation After Flash
0
1
2 9
3
4
5
6
7
8
Detect
DP
20 PPS
Detect
Crossbar
95 msec.
Equipped
Tenant 2
Equipped
No QRCU
after flash
Ignore
DTMF
10 PPS
Ignore
ESS (Electronic)
450 msec.
Not Equipped
Tenant 1
Not Equipped
QRCU/K4RCU
after flash