Toshiba Strata DK 16 - Manual (Page 11)

PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH 1993
1-7
TABLE 1-C
PROGRAM 90
INITIALIZING PROGRAMS 00 ~ 97
See Program 90 System Record Sheet
Step
#
Press...
BUTTONS + LED keys
Action description LCD RESPONSE ...
1. Use an LCD digital or electronic telephone with a
programming template.
JAN 20 SUN
NO. OF STATION (10 ~ 29)
06:30
2. * # * # 1 * 2 * 3
PROGRAM MODE
Enter programming mode.
3. SPKR 9 0 HOLD PROGRAM = 90
DATA STORE Access Program 90. System beeps after
button is pressed to indicate the program number
can be entered. SPKR
4. SPKR 90 SELECT =
Prepare system for the programs to be initialized.
5. 0 0 * 9 7 90 SELECT = 00*97
DATA CLR
Enter program numbers individually or in a range.
For a range, separate the low program number and
the high program number with an asterisk.
+ LED keys 01 & 02
6. HOLD (LEDs 01 and 02 flash rapidly) 90 SELECT = 00*97
DATA PROGRAMMED
Secures data in system programming. LEDs 01
and 02 flash.
7. SPKR 90 SELECT =
Prepare system for another selection (go back to
step 5), or exit Program 90 (continue with step 8).
8. # # HOLD 90 SELECT = ##
DATA PROGRAMMED Secure Program 90 data in system memory.
9. SPKR
PROGRAM =
Exit Program 90. Enter another program number or exit
programming mode (go to step 10).
System beeps to indicate it's exiting Program 90.
JAN 20 SUN
NO. OF STATION (10 ~ 29)
06:42
10. # # HOLD
Exit programming mode.
NOTE:
The system will not allow the
LED to light to reenter the programming mode.
SPKR
NOTE:
To initialize only one program, enter the two digit
program number followed by a
# ( # ), then press
Key 01 & 02.