Toshiba Strata DK 16 - Manual (Page 18)

PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH 1993
1-14
TABLE 1-G
PROGRAM 04
PORT AND STATION NUMBER ASSIGNMENT
Step
#
Press...
Action description
BUTTONS + LED keys
LCD RESPONSE ...
1. Use an LCD digital or electronic telephone with a
programming template. JAN 20 SUN
NO. OF STATION (10 ~ 29)
06:43
2. * # * # 1 * 2 * 3 PROGRAM MODE
Enter programming mode.
3. SPKR 0 4 HOLD
PROGRAM = 04
DATA STORE Access Program 04. System beeps after
is pressed to indicate a program number may be entered.
4. SPKR 04 SELECT =
Prepare system for a selection.
5.
7. HOLD 04 SELECT = (00 ~ 19)
DATA PROGRAMMED
Secure data in system programming.
8. SPKR 04 SELECT =
Prepare system for another port selection (go back
to step 5), or exit Program 04 (continue with step 8).
9. # # HOLD 04 SELECT = ##
DATA PROGRAMMED
Secure Program 04 data in system memory.
10. SPKR PROGRAM =
Exit Program 04. Enter another program number,
or exit programming mode (go to step 10).
System beeps to indicate it's exiting Program 04.
NO. OF STATION (10 ~ 29)
JAN 20 SUN 06:58
11. # # HOLD
Exit programming mode.
SPKR
0 0 # 04 SELECT = 00
INT = 10 Select the number of the logical port (use two digits), then # .
Initialized data assigns station numbers 10 ~ 19 DK8 or
10 ~ 29 DK16.
~ 1 9 #
6. 04 SELECT = 00 ~ 19
INT = XXXX
Enter the port's station number from the record
sheet (four digits max.).
NOTE:
Station numbers must not exceed four digits, or
conflict with feature access codes listed in Program
05 System Record Sheet.