Toshiba Strata DK 16 - Manual (Page 79)

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
2-55
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data programs timing as follows: Code 3 = 1, Code 4 = 2, Code 5 = 0, and Code 9 = 4.
3. When programming Code 9, the LCD responds with “LINE TIME =” instead of “SELECT CODE =.”
4. The duration of time the CO line circuit opens Tip & Ring when the
Flash button is pressed or when
the hookflash code Cnf/Trn 4 5 is dialed.
5. This timing is not normally used in the United States.
6. This timing applies to voice calls originated from telephones and voice or data calls originated by Data
Interface Units, PDIU-DI(2)s or PDIU-DSs.
PROGRAM 12
SYSTEM ASSIGNMENTS - BASIC TIMING
H Z Z 1 P S H S 2
Enter program code,
3 ~ 9, from table below.
Program Code Function Time
Required
Code
3
Pause Timing
(Speed Dial)
QRCU or
K4RCU Inter-digital
Release Time
(Standard Phone)
1
2
1
2
0
1
2
1
9
1.5 sec.
3.0 sec.
0.5 sec.
2.0 sec.
no pause
1.5 sec.
3 sec.
1 sec.
9 sec.
through through
SELECT = 3~9 SELECT CODE = Enter required
code for the time listed in the
table below. See Note 3.
4 0.2 sec.
Pause After Flash
(Voice Path Delay)
Flash Timing 4 4
5
9
5
6
6