Toshiba Strata DK 16 User Manual

Page 69

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS

SECTION 100-816-302

MARCH 1993

2-45

PROGRAM 92

INITIALIZING SPEED DIAL NUMBERS, VM ID CODES CHARACTER MESSAGE MEMORY, TIMED

REMINDERS, DIGITAL TELEPHONE VOLUME, AND CALL FORWARD BACKUP RAM

NOTES:
1. IMPORTANT: It is mandatory to complete all parts of Program 92 at every

new system install. If Program 92 is not completed, certain feature opera-
tions may cause erratic system behavior.

2. Use the instructions in Table 1-D (Section 100-816-301) to clear this data.
3. Program 92-9 does not affect Fixed Call Forward settings.
4. Program 92-5 does not affect digital telephone handset/headset receiver

volume levels. To set off-hook handset/headset receiver volume levels
individually for each digital telephone, see Program 30, LEDs 12 and 13.

5. Power “OFF” and “ON” is required to clear telephone LCD Call Forward

Displays and Call Forward button LEDs. Call Forward memory is cleared
when Program 92-9 is run, even if system power is not cycled.

WARNING!

Running this program will erase customer data.

Enter programming mode

END
Program 92

EXIT
programming
mode

more data

Clears Station Speed Dial, Voice Mail ID Codes,
and LCD memos assigned to Station Speed Dial numbers.

Clears System Speed Dial and LCD memos assigned to
System Speed Dial numbers.

Clears Character Message Memory (Station and System)
and user Name/Number display.

Clears Timed Reminders.

Sets speaker volume level to approximately mid-range for intercom
tone/BGM, busy override tone (muted ring), and ringing on all
digital telephones.

SELECT = (as below)

Clears Call Forward Memory and Call Forward
indications on telephones.

Power OFF
5 seconds;
then Power ON

Clears and prevents CO line access blocking.