Roland XV-88 - Manual (Page 225)

225
Quick Reference of Procedures
Appendices
Saving and Loading Data
Controlling Multi-effects
Parameters by the Slider
or Pedal
(Multi-effects Controller) Up to four Multi-effects Controllers can be used in a single
Performance/Patch/Rhythm Set.
1. Specify the MIDI messages to be controlled by each
controller (the C1–C4 slider, control pedal etc.) (see
previous).
2. The multi-effects Source parameter (PERFORM/
EFFECTS/MFX TYPE) is set to PERFORM, set the Control
channel (the receive channel of control destination) (only
Performance).
MFX Control Channel parameter (PERFORM/
COMMON/PERFORM MFX CH)
3. Choose a control source (MIDI messages used for control).
Source parameter (PERFORM, PATCH, RHYTHM/
EFFECTS/MFX CTRL 1–4)
* If you do not need to set different control sources for each
Performance/Patch/Rhythm Set, select SYS-CTRL 1–4, and use
the Control 1–4 parameters (SYSTEM/CONTROL/SYS CTRL
ASSIGN 1–4) to choose the MIDI messages that you wish to
use for control.
4. Specify the control destination (the parameter to be
controlled).
Destination parameter (PERFORM, PATCH, RHYTHM/
EFFECTS/MFX CTRL 1–4)
5. Set the Control Sensitivity (the amount of the effect that is
applied).
Sens parameter (PERFORM, PATCH, RHYTHM/
EFFECTS/MFX CTRL 1–4)
Adjusting the Keyboard
Response Sens parameter (SYSTEM/CONTROL/KEYBOARD)
Set the Keyboard to
Produce a Fixed Velocity Vel parameter (SYSTEM/CONTROL/KEYBOARD)
Saving Performance
Settings 1. In Performance mode, press [UTILITY].
2. Select “1. WRITE” on the UTIL 1 page.
3. Specify the writing destination.
4. Press [ENTER].
If a message of “Internal Write Protect= ON” appears,
change it to OFF and press [ENTER] twice.