Roland XV-88 - Manual (Page 195)

195
Chapter 11. Using the XV-88 as a GM Sound Module (GM Mode)
Chapter 11
GM CHORUS
fig.11-04
Type (Chorus Type)
Selects the type of Chorus.
CHORUS 1–4 : Chorus 1–4
FB CHORUS : Feedback Chorus
FLANGER : Flanger
Rate (Chorus Rate)
Specifies the modulation frequency of the Chorus sound.
Dpth (Chorus Depth)
Sets the depth of the undulations of the Chorus sound.
Fbk (Chorus Feedback Level)
Adjusts the amount of Chorus sound that is returned (fed
back) to the Chorus. Higher settings will create a more
complex Chorus effect.
Rev (Chorus Reverb Send Level)
Adjusts the amount of Reverb to be applied to the sound
routed through Chorus. If you don’t want to add the Reverb
effect, set it to 0.
Out (Chorus Output Assign)
Specifies how the sound routed through Chorus will be
output.
A : Output to the OUTPUT A (MIX) jacks in stereo.
B : Output to the OUTPUT B jacks in stereo.
If the Mix/Parallel parameter (SYSTEM/SETUP/
SYSTEM SETUP) is set to MIX, all sounds are output
from the OUTPUT A (MIX) jacks in stereo (p. 169).
GM REVERB
fig.11-05
Type (Reverb Type)
Selects the type of Reverb.
SMALL ROOM : Reverb resembling that obtained in a small
room.
MEDIUM ROOM : Reverb resembling that obtained in a
somewhat larger room.
LARGE ROOM : Reverb resembling that obtained in a large
room.
MEDIUM HALL : Reverb resembling that obtained in a
medium-sized concert hall.
LARGE HALL : Reverb resembling that obtained in a large
concert hall.
PLATE : Plate-type reverb effect.
Time (Reverb Time)
Adjusts the length of the Reverb time.
Out (Reverb Output Assign)
Specifies how the sound routed through Reverb will be
output.
A : Output to the OUTPUT A (MIX) jacks in stereo.
B : Output to the OUTPUT B jacks in stereo.
If the Mix/Parallel parameter (SYSTEM/SETUP/
SYSTEM SETUP) is set to MIX, all sounds are output
from the OUTPUT A (MIX) jacks in stereo (p. 169).
Making Settings for Receiving
MIDI (MIDI)
These parameters determine how each Part will transmit and
receive MIDI messages.
MIDI
fig.11-06
Channel (MIDI Receive Channel)
Sets the MIDI receive channel for each Part. If you do not
want to receive MIDI messages, turn this parameter OFF.