Roland XV-88 - Manual (Page 177)

177
Chapter 9. Getting More Familiar with the XV-88 (System Functions)
Chapter 9
Polarity (D Beam Polarity)
Switches the polarity of the D Beam controller.
With a setting of REVERSE, the direction of control for the D
Beam controller will be inverted.
D BEAM RANGE
fig.04-17
Lower (D Beam Range Lower)
Specifies the lower limit of the range of the D Beam
controller. Values below this setting will not be output.
Upper (D Beam Range Upper)
Specifies the upper limit of the range of the D Beam
controller. Values above this setting will not be output.
It is not possible to set the lower limit value above the
upper limit, nor can you set the upper limit value below
the lower limit.
D BEAM SENS
fig.04-18
D Beam Sensitivity
This sets the D Beam Controller’s sensitivity. The higher the
value set, the more readily the D Beam Controller goes into
effect. Ordinarily, this is set to 5.
Phrase Preview Settings
(PREVIEW)
Specifies how the phrase will play when you press [PHRASE
PREVIEW].
SYSTEM PREVIEW
fig.09-21
Preview Mode (Preview Sound Mode)
SINGLE : The notes specified by Note 1–4 will sound
successively one by one.
CHORD : The notes specified by Note 1–4 will sound
simultaneously.
PHRASE : The Phrase associated with the Patch’s type/
category is played.
PREVIEW KEY
fig.09-22
Note 1–4 (Preview Note Set 1–4)
Specify the pitch (C-1–G9) of the four notes that will sound
when the Preview Mode parameter is set to either SINGLE or
CHORD.
If PHRASE is selected for the Preview Mode parameter,
these settings will have no effect.
PREVIEW VELOCITY
fig.09-23
Note 1–4 (Preview Velocity)
Specify the velocity (0–127) of the four notes that will sound
when the Preview Mode parameter is set to either SINGLE or
CHORD.
If PHRASE is selected for the Preview Mode parameter,
these settings will have no effect.