Roland XV-88 - Manual (Page 15)

15
Front and Rear Panel
fig.00-03
[RHYTHM]
Selects Rhythm Set mode. → (p. 39)
[ZONE]
When the XV-88 is in Performance mode, this switches it to
the Zone mode.
→ (p. 57)
[SYSTEM]
Selects System mode. → (p. 168)
[UTILITY]
Selects Utility mode. → (p. 179)
EFFECTS Section
Used to switch on and off the onboard effects (Multi-effects,
Chorus, Reverb). When on, the button indicator for the effect
is lighted.
→ (p. 105)
[MULTI]
Turns Multi-effects on/off.
[CHORUS]
Turns Chorus on/off.
[REVERB]
Turns Reverb on/off.
Display
Shows various information for the currently selected
function or operation.
[PALETTE EDIT]/[LOCAL/TX]
PALETTE EDIT : Press this when you want to make changes
to Patch or Performance settings using the Palette page.
→ (p. 50, p. 58, p. 67, p. 94)
LOCAL/TX : When the indicator for this button is
extinguished, the Local switch can be switched on/off. When
the indicator is lit, the Transmit switch can be switched on/
off. Functions buttons are employed for this purpose.
→ (p. 25)
[EDIT]
Press this button when you wish to adjust various settings.
Use the function buttons to select the display screen for the
parameter you wish to modify.
Function Buttons
The function of these buttons will depend on the operational
mode and the status of the [EDIT] indicator.
→ (p. 25)
[1-8/9-16]
Use this button to select the group (1–8/9–16) of Parts or
Zones to be selected by the function buttons.
→ (p. 25)
[EXIT]/[PANIC]
EXIT : Press this button when you wish to return to the Play
page of each mode, or to cancel an operation without
executing.
PANIC : If for some reason notes are stuck and continue
sounding, hold down [SHIFT] and press this button to clear
the stuck notes.
→ (p. 48)
[UNDO/COMPARE]
UNDO : Press this button to restore a modified value to the
original value. → (p. 27, p. 49, p. 57, p. 67, p. 94)
COMPARE : When saving or copying Tone settings, press
this to check the sound at the save destination, or at the copy
source.
→ (p. 164, p. 181, p. 183, p. 184)
VALUE Dial
This dial is used to modify values. If you hold down [SHIFT]
as you turn the VALUE dial, the value will change in greater
increments.
→ (p. 27)
CURSOR Buttons
Press these to switch pages and to move the cursor (the
underline).
→ (p. 26)
In the Play page of each mode, pressing the CURSOR buttons
while holding down [SHIFT] allows the remote control of
external sequencers.
→ (p. 26, p. 204)
8 10
9 11
6
7
8