Link statistics, Frame relay and ppp interface statistics, Dds loopback – RuggedCom RuggedRouter RX1100 User Manual
Page 89: Current routes & interface table, 89 9.2.6. current routes & interface table, Dds link statistics
9. Configuring Frame Relay/PPP And DDS
Revision 1.14.3
89
RX1000/RX1100™
9.2.4.1. Link Statistics
Figure 9.7. DDS Link Statistics
9.2.4.2. Frame Relay And PPP Interface Statistics
Frame Relay And PPP Interface Statistics are as described in the Configuring Frame Relay/PPP
And T1/E1 chapter.
9.2.5. DDS Loopback
When at least one logical interface is configured and that interface is active, a DDS Loopback test
can be performed. This menu can be reached from a link on the DDS WAN Interfaces menu.
The remote equipment must be able to loop, allowing the entire line to be verified. If the remote
equipment is another RuggedRouter, starting a line loopback will verify both cards and the line. DDS
has no standard for performing digital loopback.
For more information on DDS loopback refer to
.
9.2.6. Current Routes & Interface Table
The table provided by this command is as described in the Networking menu, Network Utilities sub-
menu. It is also provided here as a convenience.