RuggedCom RuggedRouter RX1000 User Manual
Ruggedrouter
Table of contents
Document Outline
- About this User Guide
- Table Of Contents
- Table Of Figures
- Chapter 1 – Setting Up And Administering The Router
- Introduction
- Accessing The RuggedRouter Command Prompt
- The RuggedRouter Setup Shell
- Configuring Passwords
- Configuring IP Address Information
- Setting The Hostname
- Configuring Radius Authentication
- Enabling And Disabling The SSH and Web Server
- Enabling And Disabling The Gauntlet Security Appliance
- Configuring The Date, Time And Timezone
- Displaying Hardware Information
- Restoring A Configuration
- The RuggedRouter Web Interface
- Using The LED Status Panel
- Obtaining Chassis Information
- Chapter 2 – Webmin Configuration
- Chapter 3 – Configuring The System
- Chapter 4 – Configuring Networking
- Chapter 5 – Configuring Ethernet Interfaces
- Chapter 6 – Configuring Frame Relay/PPP And T1/E1
- Chapter 7 – Configuring Frame Relay/PPP And T3
- Chapter 8 – Configuring Frame Relay/PPP And DDS
- Chapter 9 – Configuring PPPoE/Bridged Mode On ADSL
- Chapter 10 – Configuring PPP and Modem
- Chapter 11 – Configuring The Firewall
- Chapter 12 – Configuring An IPsec VPN
- Chapter 13 – Configuring Dynamic Routing
- Chapter 14 – Configuring Link Backup
- Chapter 15 – Configuring VRRP
- Chapter 16 – Configuring Traffic Prioritization
- Chapter 17 – Configuring Generic Routing Encapsulation
- Chapter 18 – Network Utilities
- Chapter 19 – Configuring Serial Protocols
- Chapter 20 – Configuring GOOSE Tunnels
- Chapter 21 - Configuring The DHCP server
- Chapter 22 – Configuring NTP
- Chapter 23 – Configuring SSH
- Chapter 24 – Configuring IRIGB And IEEE1588
- Chapter 25 – Configuring The Snort IDS
- Chapter 26 – Maintaining The Router
- Chapter 27 – Security Considerations
- Appendix A – Setting Up A Repository
- Appendix B – Downgrading Router Software
- Appendix C – Installing Apache Web Server On Windows
- Appendix D – Installing IIS Web Server On Windows
- Appendix E – Radius Server Configuration
- Index