RuggedCom RuggedRouter RX1100 - Manual (Page 238)

26. Configuring Layer 2 Tunnels
Revision 1.14.3 238 RX1000/RX1100™
Figure 26.4. GOOSE Menu
This menu configures a GOOSE tunnel.
The Ethernet Interface field configures suitable (i.e. VLAN eligible) interfaces to listen on for GOOSE
frames. You may set this field to “none” if the intent is simply to relay encapsulated traffic between
remote tunnel endpoints.
The Multicast Address field configures the address to listen for.
The Remote Daemon and Add a new Daemon fields specify the IP addresses of remote daemons.
26.2.4. Generic L2 Tunnels Menu
Figure 26.5. Generic L2 Tunnels Menu
This menu displays configured GOOSE tunnels. Edit the configuration of an existing tunnel by
following the link under the Ethernet Interface field, or create a new tunnel by clicking Add a new
L2 tunnel.
Figure 26.6. Create an L2 Tunnel